Name: 300-liter domestic hot water storage tank with two heat exchangers DRAZICE solar boiler enameled tank with integrated temperature sensor sleeves
Brand: Drazice
SKU: HMV_OKC_NTRR_SOL_300_DRAZICE_BOJLER
Price: 1189.08 EUR

Indirect container

Volume: 275 l
Maximum weight of the water heater without water: 111 kg
Nominal overpressure: 0.6 Mpa
Maximum operating overpressure: 1 Mpa
Maximum temperature of heating water: 110 °C
HMV maximum temperature: 80 °C
Heating surface of lower heat exchanger: 0.8 m²< brother />Heating surface of upper heat exchanger: 1.2 m²
Lower/upper heat exchanger output: 19/29 kw
HMV/AH/FH permanent output: 110/760
Heating time from 10 °C to 60 °C with heat exchanger: 25/33 minutes
Heating time from 10 °C to 60 °C with heater: 8.5/6-3 hours
Power of retrofittable heating insert: 2-6 Kw
Heat losses/en. efficiency class: 1.86/B kWh/24h
Voltage of electrical safety elements: 1 PE-N 230/50 V/Hz

ATTENTION! A safety valve at each inlet connection of the storage
(blow-off pressure: 6 bar) installation is mandatory (cold water inlet, heat exchanger
inlet), and installation of a safety fitting group recommended.

More information:

HMV container

Drazice hot water storage tank with two heat exchangers, without electric heating insert 300 litersThe SOL series can do so much more for a plain container, that 2 temperature sensor sleeves are installed in the right place,
this is important!
The OKC NTRR tanks can primarily be used as tanks for domestic hot water solar collector systems. The solar collectors must be connected to the lower and the boiler to the upper heat exchanger. The containers are equipped with 1 pc in the middle height (to control the heating of the lower heat exchanger)
and 1 thermostat located on top (to control the heating of the upper heat exchanger), as well as 1 thermometer installed on top. The containers are welded, made of sheet steel, their internal surface protection is fire enamel coating.
Thermal insulation 60 mm thick hard polyurethane insulating foam foamed directly on the tank body.
The additional surface protection is provided by a magnesium anode screwed in from above.
There is also a 6/4" socket on the storage tanks at approximately mid-height, through which an electric heating cartridge can be installed.< /span>
Maximum pressure of tanks: 6 bar (0.6 MPa)